Flex Banner Introduction

• Q

  1, the composition of banner

  A

  Positive PVC, negative PVC, middle polyester mesh . 200 * 300 18 * 12 This is the specification of a wire, 200 and 300 on behalf of the thickness of the warp and weft yarn. 18 * 12 is a density within the one inch, the number of warp and weft arrangement.
• Q

  2 For example , both of 280G for 200 * 300 9 * 9 how to distinguish the same parameters’ Flex banner which is good or bad ?

  A

  Good or bad quality of PVC which is mainly determined by the level of content, more PVC can be done very bright cloth, and flexible, do not have the white break there with colour while folding . If the content is low, the cloth will be very crisp, easy to aging, there is no bright for the cloth, feeling boring, which is why the customer is always trying to send samples
• Q

  3 Why do some color different?

  A

  This is based on a favor of country, some countries like yellow, partial points to yellow, some like blue, partial points to blue, the temperature difference, we need to adjust the grade of soft and hard for PVC , cold country, we try to do a little soft spot, hot country, a little stiff.
• Q

  4 Why the mesh of the Flex Banner is irregular?

  A

  The mesh is difficult to avoid. Is a small issue of Flex Banner, the most fatal problem for the flex banner which is for absorbing Ink whether is good or not . we call coated. The quality of coating depends on print testing on the Printer .
• Q

  5, How to advise customer for such many parameters of the Flex Banner?

  A

  For ordinary mesh are 200 * 300 18 * 12 200 * 500 18 * 12 500 * 5009 * 9500 * 500 18 * 12 500 * 100 018 * 12 1000 * 10009 * 9 .these are the most commonly used Flex Banner : 200 * 300 18 * 12 (usually between at 250 - 380 g ) 200 * 500 18 * 12 500 * 5009 * 9 (usually between at 380 - 500g ) the three are the most commonly used mesh .
• Q

  6 How is the process of producing Flex Banner ?

  A

  The general production process: do PVC film first ( upside film and the end of film), and then the high temperature and mesh fiting, do not glue, the use of high-temperature melting plastic face, through the mesh of the eyes, fusion, Flex Banner general points of glossy , matte, and semi-matte, glossy surface of the product is very bright, good selling , but under the sun's light will have blind spot, for matt’s products which can be seen from all angles on the Flex Banner’s Advertising content.